Hello, to make it short I have a Jasper that i wanted to rgh ... wrote the wrong stuff on the nand couldn't access the nand via SPI got a Progskeet to program the nand. Tried everything that I could find on that.
I have a progskeet 1.21 latest Bitstream, winskeet 130721_0313, the nand as specified is hy27us08281a, running windows 8.1. Tried to program it on the xbox and off, I can read the id, it reads, erases and writes the nand but the verification fails every block 1 to 991 (after that it stops) and it says finished. Tried to dump the nand after that but it doesn't seem at all like the backup. synced the grounds, the nand is powered by a separate power supply not the progskeet. Also I connected the pre to ground and tried to leave it to N/C no change. Also tried another pc with windows 7. same problem. Will post pictures of my wiring....
I have a progskeet 1.21 latest Bitstream, winskeet 130721_0313, the nand as specified is hy27us08281a, running windows 8.1. Tried to program it on the xbox and off, I can read the id, it reads, erases and writes the nand but the verification fails every block 1 to 991 (after that it stops) and it says finished. Tried to dump the nand after that but it doesn't seem at all like the backup. synced the grounds, the nand is powered by a separate power supply not the progskeet. Also I connected the pre to ground and tried to leave it to N/C no change. Also tried another pc with windows 7. same problem. Will post pictures of my wiring....
