Proper imgburn settings for xdg3 games

[tsam2]

Hi guys.I want to know what are the proper Imgburn settings for burning XDG3 games with burnermax payload tool.I've done a copy so far and when it installs on hdd at 50% says "unreadable or scratched".The same when installing only the game data it says that "installing could not be completed try again".I used a checked abgx copy of Far Cry 4(everything was green) and a TSSTcorp CDDVDW SH-S223B drive with burnermax payload tool, which was saying burnermax is enabled.Then i used these settings on imgburn:

opc not enabled
burnproof enabled
layer brake entered manually(2133520)
buffer size set to 74mb with main to 25% and device to 50%

burned at 4x speed with maxell dvd(i didn't have a spare verbatim at the time)

 

[GeekHeat]

Best using verbatim made in Singapore or UAE.
Other brands u will need to mess with the settings alot and u still may not get a good burn.

 

[tsam2]

Best using verbatim made in Singapore or UAE.
Other brands u will need to mess with the settings alot and u still may not get a good burn.

Yeah i know i just didn't have verbs at the time.So for verbs:

Verbatim MKM-001 = 2.4x with OPC in IMGBURN disabled and Verbatim MKM-003 = 4x with OPC in IMGBURN Enabled

and i will see with other brands what i can do later.

 

[tsam2]

Just used dvdinfo and checked the quality of burn.It checked only the half of it(4gb) and then stopped.I'm trying an older back up of a game (Dead or alive Xtreme 2) and it is reading both layers.So i guess i did a very bad burning...