RGH (QSB) soldering problem

lewisgreg981

lewisgreg981

BANNED
Jan 30, 2011
27
0
G,SC
Ok so I soldered my (QSB) onto my slim, put the power cable into the back of the slim (not turning it on), Connected the QSB to my Nand X using the supplied cables, and non of the programs are detecting my console.

I used (Nandpro 3.0 W/installed drivers from 2.0),
J-Runner,which crashes whenever I click read nand,
And I even tried an ancient program like Jtag Tool:facepalm:. I check the soldering like 3 times without frying it and it seems fine.:confused:

And if it's cool to post here if I cant find a way to fix it could I get someone (A PRO) to fix it for me? I will even supply the tools to do it for under $30. The coolrunner,qsb,cables, and even the nand x if I have to.




Ok it might take me about 15minutes to take apart and to send picture from my iphone to dropbox.

I might be sooo stupid it I tried this on a corona :facepalm:

Sorry This is best quality I can get
 
Last edited:
2

2615863

VIP Member
Nov 30, 2011
552
33
Tampa,FL
Make sure there are no bad/cold solder joints... especially the ground..
 
2

2615863

VIP Member
Nov 30, 2011
552
33
Tampa,FL
It looks like your points are bridged, or so it seems.. I can fix it and Ill get the dumps for you.
PM Me.
 
Last edited:
2

2615863

VIP Member
Nov 30, 2011
552
33
Tampa,FL
BL4K3Y said:
Look to the right of the green QSB socket, you bridged those pads :facepalm:.
Click to expand...
Same as I was saying, sometimes unbridging can be a bit difficult, without unsolder braid/ solder sucker.

To OP: like I said I can fix it for you and get you those nand dumps, if your going to put a coolrunner, I'll solder the wires for you as well.
 
RROD!

RROD!

VIP Member
Apr 13, 2011
786
0
2615863 said:
Same as I was saying, sometimes unbridging can be a bit difficult, without unsolder braid/ solder sucker.

To OP: like I said I can fix it for you and get you those nand dumps, if your going to put a coolrunner, I'll solder the wires for you as well.
Click to expand...
all for free what a guy sounds like a good deal
 
keil423

keil423

VIP Member
Apr 4, 2011
1,954
88
South Dakota, USA
www.epicconsole.com
First off that is a trinity mobo. Second you seem to have at least to bridges which I marked with a red line and a yellow arrow pointing to them.

Get some desoldering braid and remove the bridges. Try again. Before you alter any of the programing you should hook the console up again and make sure it still boots up.

To have not known that those bridged points would cause you console to behave as it is serves as a sign to me:crazy:. I hope for you that you didnt damage the Stby_Clk point on the right side of the QSB.

If you cant see the picture clear enough you may have to save it and open it in a program where you can zoom in. You didnt really give me much to work with for quality!
 
Last edited:
  • Like
Reactions: x360ccm
You must log in or register to reply here.