hi, i have ordered r-jtag ultimate kit for one jasper that i have sitting around log time. my question is, it's easier to make all the installation with QSB? the audio_clamp it's optional or mandatory to this type of installation??? it's the first time that i made one jtag installation, all that i did was RGH (too much)until today.
QSB ??
- Thread starter <storm>
- Start date
Pretty much as easy has RGH
you'll need to play with it to get the best boot times.. Aud_clamp is one of the Options
As for the QSB you get them why not use them
you'll need to play with it to get the best boot times.. Aud_clamp is one of the Options
As for the QSB you get them why not use them
Nadles
VIP Member
Comes down to personal preference. I personally enjoy having them. If I have them, if its my personal Xbox, I use them. Much cleaner install.
TheGlow
VIP Member
The ones for dumping the NAND I didnt bother with.
The jtag qsb I used a bit at first for resistor testing then opted to do old school diode wiring.
Post qsb is pretty much mandatory as it simplifies all the wiring to the nice ribbon cable.
The only work I'd done previous to rjtag was an RGH and Demon on my jasper.
I did the rjtag last week, then did another for a falcon, and another rjtag/demon for a different falcon.
The jtag qsb I used a bit at first for resistor testing then opted to do old school diode wiring.
Post qsb is pretty much mandatory as it simplifies all the wiring to the nice ribbon cable.
The only work I'd done previous to rjtag was an RGH and Demon on my jasper.
I did the rjtag last week, then did another for a falcon, and another rjtag/demon for a different falcon.
BL4K3Y
VIP Member
QSBs are not *required* but they will make your install look much cleaner.
AUD_CLAMP was the recommended wiring for HDMI JTAG consoles back in the day, but you should go with what gives your console the best results.
AUD_CLAMP was the recommended wiring for HDMI JTAG consoles back in the day, but you should go with what gives your console the best results.