DGX Question about demon and rgx x7 and x8 and EN

[CaptainBlood]

http://imageshack.us/a/img35/3417/95nz.jpg

Uploaded with ImageShack.us

Hi

1) for RGX and DNDemon i need install the ORANGE wire (x7 kiosk) too? or is ok whitout orange wire too?
And the orange wire is only for "prorate feature" for cr3pro right??

2) I need also connect a write from "EN PIN connector" to this -> http://team-xecuter.com/forums/attachment.php?attachmentid=14787&d=1362922888 right? (I ask becouse i don't know if the new software rgx need to do this)


3) If i don't want to use the !DSWITCH feature X8 is not needed right?
And if i i want use the !DSWITCH Feature whit rgx i just install wire from X8 to 3V3 standby on the motherboard only? or i need X7+X8 whit DGX for !DSWITCH?

 

[alexander_1333]

Hi

1)No, only if you want to powre on/off the xbox from PC or use DSWITCH.For the PROrater function you need to solder K point from CR3.

2)Yes, if you use retail on xbox NAND and freeboot on DemoN NAND.If you use two hacked NAND-s(i.e.:Fusion/freeboot) EN pin should be unsoldered

3)If you don't want to use the DSWITCH feature X8 is not needed.And if you want to use the DSWITCH Feature whit rgx solder a wire from X8 to 3v3 NON-standby on the motherboard.Kiosk wire also should be soldered.

 

[CaptainBlood]

Hi

1)No, only if you want to powre on/off the xbox from PC or use DSWITCH.For the PROrater function you need to solder K point from CR3.

Ok perfect thanks!!!

2)Yes, if you use retail on xbox NAND and freeboot on DemoN NAND.If you use two hacked NAND-s(i.e.:Fusion/freeboot) EN pin should be unsoldered

Thanks so much! no no i want use retail + freebot,thanks so much!!

3)If you don't want to use the DSWITCH feature X8 is not needed.And if you want to use the DSWITCH Feature whit rgx solder a wire from X8 to 3v3 NON-standby on the motherboard.Kiosk wire also should be soldered.

Ok thanks so much really whit all my heart!. <('<)smuack<('o')>

 

[alexander_1333]

2)Solder the orange wire to the CR_EN point on DemoN instead of EN on the litle daughter board.The daughter board can now bee removed.

 

[CaptainBlood]

2)Solder the orange wire to the CR_EN point on DemoN instead of EN on the litle daughter board.The daughter board can now bee removed.

edit: aaah ok orange write from chip Pin to EN demon,ok ok i understand.

 

[CaptainBlood]

edit: dam.
edit2: mmm But if i remove the demon-cr the little board,where i put then the flat cable from dual nand demon to demon-cr
edit3: But the flat cable,is for what? O__o flat cable that go from demon to demon-cr
edit:
Done thanks!!!
http://imagizer.imageshack.us/v2/1280x720q90/801/pkze.jpg
http://imageshack.com/i/m9pkzej