question about pin 8 on lpc rebuild

[Project-X's3]

ok i've checked my soldering job and it looked ok, except for pin 8. it was soldered to the lpc rebuild board, but does it have to be soldered to the little point just to the left of the lpc. sorry can't get a picture of it. but its here.

 

[junkman2]

No, It only has to be soldered to the rebuild board and make sure that the solder goes down to the lpc hole also.

 

[Project-X's3]

sorry man i've just check my board and it is not pin 8 it is pin 7. the pin that is supposed to be soldered to the D0 point. this pin 7 was not soldered to the d0 pt. do i have to with the lpc build.

 

[junkman2]

d0 is soldered to the rebuild board. Then take the grey wire and solder it to the d0 on the rebuild.