Question about pro switch and Lcd

[XtremeGameConsoles]

Just a quick question I got my chip installed and working haven't flashed it yet but had a few problems with solder joints on 15 and 9 and no 3.3 volts got that fixed and was installing the pro switch crystal version and I was wondering does this suppose to snap into the base of the case with the two prongs? I got an after market clear case and it didn't want to fit exactly so I made a few minor adjustments. Also what type of cutter blade on a dremel would you recommend to cut the slot for the LCD?

Nathan

 

[fxE20170]

you can use the sticky stripe supplied with it then snap it under the xbox (the vent holes) I just installed mine and I recommend you route the cables by the 2nd controller as supposed to controller 1. (as you would using the regular switch provided) as far as the dremmel i used a regular black and decker nothing fancy....it should be better for you being that you have the clear version...