LITEON 0225 Questions about flashing back to stock

S

scrillaINmanilla

Full Member
Dec 2, 2011
28
0
okay so i just read the LT+ v3.0 is going to be released christmas eve.so i wanted to make sure im ready.

my liteon 0225 has a TX replacement pcb board.let me run through it and if someone can let me know im right or wrong would be greatly appreciated.

so flashing back to stock i use my original dummy bin i got from my first flash.is that loaded as source? or do i use the stock firmware? and thats will be loaded as target right? and do i have to read my firmware wen i do this or do i just load LT 2.0 as the source?

LT 2.0 was my first flash.

okay so say im correctly flashed back to stock. do i have to reassemble and do xbox update.

once again i appreciate any help
 
S

scrillaINmanilla

Full Member
Dec 2, 2011
28
0
so thats it huh? no read right? just load target and source press spoof. cool thats easy enough thanks. but from there do i flash the new LT3.0 or do i hae to put it together and do xbox update? or do i not even have to worry about the update?

thanks +rep
 
3

360playa

Junior Member
Nov 30, 2011
11
0
Carolinaz Boi
If you want the latest update then you want to spoof the drive to stock then download the latest update then flash the dvd drive to LT3.0
 
S

scrillaINmanilla

Full Member
Dec 2, 2011
28
0
cool i think i got it. another question is when should i hit the WP switch on my TX pcb board? i pretty sure i do that right away.
 
S

scrillaINmanilla

Full Member
Dec 2, 2011
28
0
yup lockpicker thats the exact tut i used to flash it oiginally

so let me run through it and if someone can let me kno if its right be great

so my original dummy is source stock OFW is target just press spoof. okay so that part is done

i then reassemble xbox power on do xbox update then just flash again like it was new right???

i think i get it.i hope i do lol so when should i switch it to WP0 on the pcb im assuming immediately.
 
Last edited:
You must log in or register to reply here.