HITACHI NON-79 Quick question about CR4 XL and xell writing

[sastek]

Hi, I'm in the process of installing my first CR4 XL into a Falcon, I'm going to wire for RGH2+ because I only need it for key retrieval.

In this thread it says to read nand then manually load the downloaded falcon.ecc file from the RGH2_ECC folder. I just want to check if this is still necessary with the latest version of jrunner or if I now just need to select glitch2 and cr4 then create ecc?

 

[GeekHeat]

Hi, I'm in the process of installing my first CR4 XL into a Falcon, I'm going to wire for RGH2+ because I only need it for key retrieval.

In this thread it says to read nand then manually load the downloaded falcon.ecc file from the RGH2_ECC folder. I just want to check if this is still necessary with the latest version of jrunner or if I now just need to select glitch2 and cr4 then create ecc?

there is no need to manually load it with latest j-runner. So just select glitch2,cr4,create ecc, write ecc.

 

[sastek]

there is no need to manually load it with latest j-runner. So just select glitch2,cr4,create ecc, write ecc.

Thanks.

Not sure how I ended up with [Hitachi non 79] in the title, I was aiming for [RGH]! guess I must have overshot the selection :smile: