GENERAL quick question about rgh2 trinity

[zymagoras]

hi all i have trinity slim and coolrunner rev.a taken off falcon phat. it has cap removed, so as far as i understand it's only rgh2 now and i need rgh2 for trinity. dash is 16537. am i good to go? thanks in advance!

 

[ezzda1]

Yes it should work fine on a trinity

 

[zymagoras]

also do i need 10 ohm resistor for slims?

 

[ezzda1]

Not usually, It depends what gives you the best boot times.
try without first, if it takes ages to boot try it with it.
every trinity I've done usually boots within 15 seconds.

 

[Joo C]

yes ezzda1 right

Another useless post dude, can u stop with this sh*t already!

 

[BL4K3Y]

i think u need 10 ohm resistor

Why?

Every Trinity console I have glitched using a normal CoolRunner glitches far better without a 10 Ohm resistor on CPU_RST.

OP: Keep the slim blue wire as long as possible (it's 55CM I think) and wrap it loosely around the X-Clamp.

 

[GeekHeat]

Another useless post dude, can u stop with this sh*t already!

I agree, getting out of hand now.