RGH Quick question

[dingle01900]

Hi i have my coolrunner soldered in place ready for programming when my coolrunner update cable arrives tomorrow. My problem is i cant read the nand on the console with coolrunner installed"no flash controller detected" . The console is jasper. Spent about 2 hours trying different settings to get it to dump. Wired my cable up to my falcon and dumps 1st time. So is the coolrunner not being programmed the problem? Thanks

 

[Dimrain13]

post a pic of the install of the nand wires

 

[dingle01900]

No access to a camera ATM will post when i do. Although the soldering is fine, even tested connections with a multimeter and all are fine : /

 

[Dimrain13]

u do not need the coolrunner installed to read your nand, you need you 360 connected to the power brick and NOT turned on.. you have done all this?

 

[ccNick]

Is the console connected to it's power brick?

Dimrain13 beat me to it

 

[Dimrain13]

Yes connected and dont turn it on, i needs to draw power from it but once u turn it on it will put out to much and potentially damage what ever device you are reading the nand with.