R-JTAG Cannot boot to Xell Reloaded

E

[email protected]

VIP Member
Jun 21, 2012
383
0
banjojohn said:
I decided to kind of start from scratch. I reloaded the original NAND and guess what? - RROD. So I've f****d up somewhere. I guess that could be anywhere I've soldered, or? I haven't looked into the error code reported from the RROD (starts with those standard 3 lights (excluding the top right one, I think), but right now I haven't got the complete error code. Would that be useful at all at this step.
By the way, I am looking into persuading one of my friends to help. He does a much better solder job than myself.

Regarding the RROD: I removed the R-JTAG, the JRunner and turned the QSB off. Should start with original NAND to my knowlegde.
Click to expand...
after you re-load original nand unplug power cord and plug in back, otherwise you might get RRoD, I had the same thing on two Zephyrs I was working on recently
 
B

banjojohn

Junior Member
Oct 15, 2011
17
0
I will return with complete error code if unplugging power cord doesn't. I'm fairly sure I did try that, though...
 
B

banjojohn

Junior Member
Oct 15, 2011
17
0
Got the error code. It only takes 4-5 seconds from turning it on until it blinks. The code is 0022 meaning E10. So my guess is I've blown a soldering or bridged something that shouldn't, right?
 
You must log in or register to reply here.