R-jtag jtag alt board issue

[HDPredator]

I killed my jtag alt board due to bad soldering is there a alternative wiring I can do ?

 

[DreamZ]

Wire up normal jtag wiring

 

[HDPredator]

Just with the diodes or the bridge connection Aswell?

 

[Martin C]

Just with the diodes or the bridge connection Aswell?

Do you bridge the points for a JTAG solder? I think you do.

 

[HDPredator]

Ok cheers and where do I wire the aud_clamp wire to as it was on the jtag alt board

 

[Martin C]

Get yourself a meter. Set to continuity.

Answer all these 'where do I solder this' questions yourself

 

[TheGlow]

Points are listed from the top point of view. You can just mirror/swap and do on the bottom.
Depending on the status of the board, hopefully you can still use it with a wire install to the blue points, J2D2.4 and 7 to test out the resistor values.
Red wire you can wire on top to that point or the point the qsb uses.
For yellow, same, wire that on bottom with diode to the Q2N1 aud_clamp spot.
Go to radio shack and grab a pack of 330 ohm and 470 ohm resistors, and the diodes. run you about $1.50 per pack.

 

[DreamZ]

Diagram above the yellow wire goes to audclamp q2n1the red is db1f1 you can use the alt point near the alternative stbyclk where the jtag qsb goes to.

If you use non audclamp the yellow wire goes to rol alt or rol pad