r-jtag ribbon cable messed up now console wont boot stock or freeboot

[briggs01]

i have a spare ribbon if you pm your address il get it out to you budy

 

[jagmez]

tried a 40 pin IDE cable cut down to the 8 wires and it glitches 6 times then get code 0001. I believe this is power supply problem from what i have looked up. The console boots up good with stock nand now not sure why i just flashed the original nand a few times and finally it worked.

 

[xzanox]

I know by experince that R-jtag does work with the ribbon cables from CR3 Pro since i accidently destroyed one when i was tired and the cable stuck in front ot the HDD port. The ones from CR3 Pro are a bit longer than the stock, but as i said they work.

That is good to know, will help a few people...