FIXED Rater not powering up xbox R-jtag+

[soda530]

Console Type: Jasper
· Programmer Used: JRP v2.0
· NAND Size: 256GB
· Dashboard version: 2.0.17150.0
· CB Version: 6754
· Was the console working before you started: Yes

I'm using rater to find the best settings for my Jasper because my glitch cycles are a bit long. When rater runs I have to manually turn on the xbox because the "power up" cycle won't turn it on. It will however turn it off. I've got my CR4 XL wire-installed with no QSBs on the top of the board, and I'm using the AUD_Clamp QSB v3 on the bottom. What am I missing?

 

[BL4K3Y]

You are probably missing the KIOSK (K) wire.

Solder a wire from pad K on the CR4 to the solder point next to 5V on the motherboard.

You should also solder the green wire from your JRP - this is used to power the console down during RATER testing.

 

[soda530]

Bingo. That was it. Once I installed the green wire from the K pad to the solder point next to 5V on the motherboard rater would power up the console. Thanks for the help!