[RDOD] Corona v1

[Goldeneye]

Hello,

I tried to glitch my c1 motherboard a while ago, but managed to get a rdod / e74

I was wondering, if you could see any bad spots on the QSB, or any place else, or if it's possible to send my motherboard to one of the tech guys around here for repair :redface:

Some pictures wer too large to be attached, so click here to see them all ( sorry for the outside link.. ).


Thanks in advance.

 

[Oggy]

The error is 0032? I dont think R4D4 is on the RST line on ****ronas.

 

[Goldeneye]

the error is 1033 / E79

and the error code without the R4D4 => CPU_RST is 0013 with a blinking red dot, which seems to be a RAM issue?

thanks for the quick reply

 

[Martin C]

Some pictures wer too large to be attached

read the links in my sig.

 

[Goldeneye]

read the links in my sig.

I know I could resize them, but this method works aswell, right?

 

[chase]

your cpu_rst is wired to the wrong point.. fix that and see what happens

if that doesnt fix it, check if stock nand boots

 

[Goldeneye]

your cpu_rst is wired to the wrong point.. fix that and see what happens

if that doesnt fix it, check if stock nand boots

the stock nand is flashed..
where does cpu_rst need to be wired to then?

 

[chase]

if you remove 5v from CR3 pro, stock nand boots ?

pick one on of the points below for cpu_rst

 

[Goldeneye]

if you remove 5v from CR3 pro, stock nand boots ?

pick one on of the points below for cpu_rst

I assume you're talking about the QSB, as I don't have a CR, but no, it doesn't boot.

I will try your cpu_rst points and will report back asap
thank you all.

btw, without the wire between R4D4 to C5R11 ( cpu_rst fix ), the fan starts going crazy, giving me a blinking red dot, and will turn itself off after 5 - 10 seconds. ( no wire from R4D4 to C5R11 )