Re-using coolrunner rev c

[saxxp]

Can you de-solder and re-use the coolrunner rev c after you're preformed an rjtag?

The logic i'm using is ; Once you've already ran coolrunner and used it to install xell and the jtag, you can remove the coolrunner and leave the jtag intact and it will still work.

Am i wrong?

 

[WalangAlam]

no. you need the rev c at all times. rev c is for rgh/rgh2. rjtag, rjtag chip.

 

[scott1503]

Rev c is used for rgh1 or rgh 2 and is needed for the rgh hack to run and cannot be removed with returning your console back to its original state.

r-jtag is initiated by installing a r-jtag chip but same applies to rgh you would need to return to original state

finally jtag the only way known that you don't need a chip you need a console on dash 7371 or below but you don't need to have any type of chip installed just a few diodes and wires

 

[saxxp]

Ah i see. Coolrunner revc isn't an rjtag chip. I need to do more reading.

 

[rick48235]

Ah i see. Coolrunner revc isn't an rjtag chip. I need to do more reading.

no its not