RE: Xapt3r Install (sticky by Xecuter)
Sorry to post this outside of the sticky thread, but the thread is closed.
I just noticed one error, and I want to save people (especially Noobs like I was) from pulling-out their hair.
It says that the red light will glow (remain lit) once a good D0 connection is made - this was not true on my installation (v1.5). The red LED will only remain lit once you have a good D0 connection AND the modchip is installed on the Xapt3r. If the modchip is not installed, and you have a good D0, the red LED will flash once/twice on boot-up, then go dark.
Xecuter - if I am correct, can you make a note in your install tutorial? BTW thanks for putting that up, a lot of people have been asking about how to install the Xapt3r.
Sorry to post this outside of the sticky thread, but the thread is closed.
I just noticed one error, and I want to save people (especially Noobs like I was) from pulling-out their hair.
It says that the red light will glow (remain lit) once a good D0 connection is made - this was not true on my installation (v1.5). The red LED will only remain lit once you have a good D0 connection AND the modchip is installed on the Xapt3r. If the modchip is not installed, and you have a good D0, the red LED will flash once/twice on boot-up, then go dark.
Xecuter - if I am correct, can you make a note in your install tutorial? BTW thanks for putting that up, a lot of people have been asking about how to install the Xapt3r.