read bb 512 jasper nand wrong

[mjfaderway]

hope someone can help
dumped the full nand all 512mb and then did 64mb and made a ecc image and wrote it but didn't get the green light flashing and no xell so had a check over then wrote back the original nand and now nothing :facepalm: no red lights just flashes a green dot on the rf board so tried opening the full nand in 360 flash tool and it wont open the nand file
i also made two 16mb nand file before i noticed i had the wrong command :facepalm:


any ideas any help would be great


thanks in advance

matthew

 

[keith6625]

you did program the CR right just asking have to make sure

 

[mjfaderway]

yes double checked that


also i cant create a ecc image with the 512 dump or the 64 on either muti b or jtag tool only 16mb

 

[Martin C]

Did you not open your NAND in 360 flash dump tool before writing anything?

 

[mjfaderway]

i didnt no:facepalm: i feel like a right noob
ive only written the ecc and a full nand dump back
i can only get the two 16mb dump i did to open in 360 flash tool

is this console savable martin ?

 

[mjfaderway]

ok well the console boots fine with the cr removed

 

[BL4K3Y]

Re-dump the NAND, but only dump 64MB this time!

 

[mjfaderway]

will do 3 times like i normally would:tongue:

 

[Martin C]

When you open the dump in 360 flash dump tool, go to edit config. If you see all FFFFF's then you haven't dumped the right size.

Unless you know 100% for sure that your NAND is 16MB, dump 64MB. If the config shows as above, it's a 16MB NAND. Re-dump as 16MB.

 

[mjfaderway]

all done now cheers guys please close

happy new year