I hope I don't get flamed about this. Like the title says I have a rrod mobo that I use for practicing my solder skills, I can solder wires all right but I've never solder qsb's. If I solder the qsb's included in the nand-x kit can I read the nand since I don't have to power on the console? thanks for your help...
read nand on rrod mobo?
- Thread starter Akilles
- Start date
As long as the Power Brick doesn't go red when u plug it in yes you can. Just solder the QSB correctly and Dump the Nand to your computer
BTW i dont know if it's just me but i can never for the life of me Desolder those QSB's so make sure you can get them off without damaging them
BTW i dont know if it's just me but i can never for the life of me Desolder those QSB's so make sure you can get them off without damaging them
Thanks guys for your replies. Indeed the power brick doesn't turn red when I connect it so I will give this a try tomorrow. Thanks again.
keil423
VIP Member
I had a hell of a time desoldering my QSBs also! I might try a sucker to see what they are all about!BTW i dont know if it's just me but i can never for the life of me Desolder those QSB's so make sure you can get them off without damaging them
I guess I just figured the QSBs are cheap enough to leave them in.
>>>End Hijack!!!<<<
skiiermike
Senior Member
Try some desoldering braid, I've had great success with that. If you don't have any, stripped speaker wire works great to.
Use a sucker. I have two different ones I use. Tried desoldering braid and didn't like results at all.