so i read my nand b4 but then i got a new cool runner and then i solderd the nand x and then it was reading it but i was holding it and i moved and then it said error so i exit that and started agian and it says incompatible arm firmware for this version of nand pro ??? any ideas???
ANSWERED reading my nand
- Thread starter HeLL HAZARD13
- Start date
BL4K3Y
VIP Member
OK my question is why are you holding anything lol the wire's should be solider on for your nand x or the pin headers that came with your nandx installed....:facepalm: Now the reason your getting that error is one yes cause you moved some thing also you are going to have to unplug your nandx an plug it back in an open up a new command prompt but for future reference solider the wire or use your pin headers so nothing moves......
hahaha i know i was just seeing if it worked and when i moved i was like S***** ahaha thanks im try that right nowOK my question is why are you holding anything lol the wire's should be solider on for your nand x or the pin headers that came with your nandx installed....:facepalm: Now the reason your getting that error is one yes cause you moved some thing also you are going to have to unplug your nandx an plug it back in an open up a new command prompt but for future reference solider the wire or use your pin headers so nothing moves......
all i gotta say is be careful soldiering cause there is so much room for error when you are soldiering :rolleyes2:
Martin C
VIP Member
I don't know what you expect anyone to do about this. You shouldn't be holding anything in place. That's what solder is for. I also don't get why you were messing with the NAND if you were changing the coolrunner.