Reading The NAND

[Astride]

I can't seem to get the NAND to read. I have read all the guides and I think my soldering is okay. But there is one problem I can think of; I messed up the soldering by soldering to joints together so I removed the QSB and whilst doing that it removed about 3 of the solder pads on the bottom of the QSB. Is this relevant to dumping the NAND or is it just the top ones that are being used?

Here are some pictures:

http://img810.imageshack.us/img810/6034/imag0261l.jpg

http://img844.imageshack.us/i/imag0263g.jpg/

http://img513.imageshack.us/i/imag0264i.jpg/

 

[rocket8080]

If you have removed the solder pads from the bottom of the qsb's then yes it wont read the nand. Remove the qsbs and either solder the wires directly to the board or use the pin headers. People have less problesm doing it this way then using the qsb's.

 

[Astride]

I cut the wire off the Pin headers and soldered them directly onto the board. Reading NAND fine now. Thanks alot for being helpful.

Requesting thread to be closed.

 

[rocket8080]

No probs mate, that is what these forums are about! helping each other.