Team-Xecuter Community
So I have had a couple of failed verifications with imgburn. They were failing at 50% and a few were at 96%. Because of this I started doing kprobe scans, my scans show a large fat spike at 50% then it stays high and peaks again around 96%.
so 0%-about 45% is very low (within stated requirements) then the huge spike and it does not go anywhere near where it should then the 96 percent is almost as high as 50%
these are mkm 001's
has anyone had similar failures, is there a fix, or a recommended setting?
I purchased a replacement, but if I can replace the laser or reflash the drive to fix it I would like to do that.
so 0%-about 45% is very low (within stated requirements) then the huge spike and it does not go anywhere near where it should then the 96 percent is almost as high as 50%
these are mkm 001's
has anyone had similar failures, is there a fix, or a recommended setting?
I purchased a replacement, but if I can replace the laser or reflash the drive to fix it I would like to do that.