rebuild 1.6 using top points...

[exstasy]

i was planning on rebuilding a friend's lpc port by using the points needed for the xapt3r 1.6 install... but looking at the diagrams, i cant figure out which letters correspond to with lpc pin.. could anyone help me out here? thanks

 

[Fantmx]

This is the LPC rebuild wiring. http://www.teamxecuter.com/x3/tutorials/16/x3_16rebuild.jpg

 

[exstasy]

oh i forgot to mention that the traces on the bottom have been lifted by his faulty install.. so i need to rebuild it using the top points... looking at these install diagrams, http://www.bald.claranet.com/xapt3r16b.jpg i cant tell which letter corresponds to which lpc pins... any help would be appreciated... thanks

 

[Fantmx]

Check this link out. It is a sticky on top of this section. http://teamxecuter.entryhost.com/forums/showthread.php?t=7284 If you do that be very careful, because you could easily damage the board.