my 360 seems not not want to work... my power supply light is red when i plug it into the 360.. i have tried all wall sockets and 3 different power plugs. same result. im not sure if there is a short in it somewhere or whats going on with that...but i took all of the wired out (AUD_Clamp) and nandx wires. still nothing.. i havent put any other firmware on yet just read the nand.
JTAG Red light on Power supply? Help!
- Thread starter Dimrain13
- Start date
Hello69
Noob Account
- Sep 9, 2011
- 4
- 0
Are you trying to Jtag it or was it already Jtaged; and if your Jtaging it did it work fine before you started to Jtag it?
not sure what i did but it now works... i just messed with the power button a bit and not it gives me what i want.
have you checked to make sure you didn't cross over any solder points if it worked before then sounds to me like it may be in the soldering maybe a point touching another?
---------- Post added at 19:53 ---------- Previous post was at 19:52 ----------
hmmm weird I'm not sure what it could be then maybe rol going bad I'm not to sure lol