Remove JTag?
- Thread starter iPwny
- Start date
Coleman
VIP Member
If you want it back to stock then grab the jrunner app build a retail NAND and flash it to the console, remember by doing this you'll blow the efuses and need a glitch chip if you ever wanna run home brew stuff again, also make sure your LDV is correct or you'll end up throwing rrod errors.
Correct me if I'm wrong!
Correct me if I'm wrong!
console repair world
VIP Member
can you not just do an official ms update then remove the wiring?, i may be wrong but havnt had the need to ever to this
dx5512
VIP Member
I doubt it, returned a rgh back to stock had to remove the wiring and coolrunner AND flash back to stock nand. However this is a RGH and not a JTAG and there are some little but important differences between the 2.
Last edited:
console repair world
VIP Member
an official update on orig jtag was known in the day to give rrod untill wires were removed, then it was a standard console.
im open to criticism here as still not 100% certain, was under the impression the officail update just updates the dash with keeping the current kv and stuff, bit like the option in flash360.xex, unless efuses were protected.
please if im wrong correct me
im open to criticism here as still not 100% certain, was under the impression the officail update just updates the dash with keeping the current kv and stuff, bit like the option in flash360.xex, unless efuses were protected.
please if im wrong correct me
Extract and use flash360
http://www.mediafire.com/?mmiwvhwmmje
Run it from xex menu or what ever you use and dump your nand to a memory stick, then use xell to get your CPU key if you don't already have it and build a retail nand with your fresh dumped nand and cpu key in the jrunner app, then simply flash it back the same way you dumped it and you should be on a retail dash after you flash it and then unsolder the jtag wires, I did this a few months ago to a customers console, good luck keep us updated
http://www.mediafire.com/?mmiwvhwmmje
Run it from xex menu or what ever you use and dump your nand to a memory stick, then use xell to get your CPU key if you don't already have it and build a retail nand with your fresh dumped nand and cpu key in the jrunner app, then simply flash it back the same way you dumped it and you should be on a retail dash after you flash it and then unsolder the jtag wires, I did this a few months ago to a customers console, good luck keep us updated