Hello,
I successfully managed to two Xbox's, but these were RGH1. Now I have an Xbox that needs RGH2. I purchased a CR rev. C, that I also used for the previous Xbox's. Jumper settings according to the RGH2.
Xbox type: Falcon
CB: 5774
Dash: 16202
NAND dumping: LPT
After writing the ECC file, I tried all the timing files, shorten wires, removed cap, add 10ohm resistor. Green light was flashing, but it did not glitch.
Before I started I made NAND dumps, but there are two bad blocks. Now I don't have a CPU key, since it did not glitch and I want to restore to the original NAND.
How do I repair the original NAND without a CPU key? And can I just write the repaired original NAND with the following command: nandpro --w16 originalNand.bin
I be happy to provide you addition information. Please help me out.
I successfully managed to two Xbox's, but these were RGH1. Now I have an Xbox that needs RGH2. I purchased a CR rev. C, that I also used for the previous Xbox's. Jumper settings according to the RGH2.
Xbox type: Falcon
CB: 5774
Dash: 16202
NAND dumping: LPT
After writing the ECC file, I tried all the timing files, shorten wires, removed cap, add 10ohm resistor. Green light was flashing, but it did not glitch.
Before I started I made NAND dumps, but there are two bad blocks. Now I don't have a CPU key, since it did not glitch and I want to restore to the original NAND.
How do I repair the original NAND without a CPU key? And can I just write the repaired original NAND with the following command: nandpro --w16 originalNand.bin
I be happy to provide you addition information. Please help me out.
