Replace DG-16D2S with DG-16D2S

[tsam2]

Hi guys.I want to spoof a lite on DG-16D2S with another DG-16D2S.They have the same fw(74850C) and hw(A0A1) written on top of the drives.In fact they are manufactured just a month later(june and july 2008).So i followed the jungleflasher guide and i have the dummy bin from the original lite on.Now i connect the new lite on, i open the dummy bin as source fw, then stock fw(with my key injected) as target, i press "spoof source to target" and on mtk32 "lite on erase".Then pops up a message saying "Target DVD Key Cannot be verified for drive!".Is it normal?Should i proceed or am i doing something wrong?

 

[playingmax]

since you have the original dummy file no need to spoof. once u open source firmware the loading source window will pop up. click on yes and just flash it.

 

[tsam2]

since you have the original dummy file no need to spoof. once u open source firmware the loading source window will pop up. click on yes and just flash it.

Basically i was worrying about the message "Target DVD Key Cannot be verified for drive!" which i think is normal since i'm replacing with another drive.In jungleflasher everything is explained in detail and i was skeptical why it doesn't mention this in the procedure and i wanted to be 100% sure.Anyway i managed to do it.Thanks.

 

[keil423]

it's usually says that when you haven't dumped the drive on that computer before. So it can't verify that it matches that drive. Which it doesn't since it's a replacement.