GENERAL Replacement PCB worked fine, until day 2.

[Cameron_M]

I not really a noob, but I thought this was the right section.

Flashed a 9504 slim (0272) with a replacement pcb v1.1. No errors or anything, locked the pcb at the end on jungleflasher and then hooked it up to the drive, installed correctly (I have done about 10 or so). Works perfect for yesterday and today, but all of a sudden it won't read discs and it will only eject 1-2 inches. It ejects manually fine.

If anyone else has experienced this it would be helpful to hear your insight. Tomorrow I'm going to test all the functions hooked up to the computer. Thanks.

 

[Utmad]

Did you use the connector block for attaching the wires or soldered direct, if the previous then maybe a wire has come loose.

 

[Cameron_M]

not soldered, and yes that is what I am expecting. Must be that, I just created this to see if it was anything more complicated, thanks for the input, I hope it's that simple.