Just think that a check list wouyld be very helpful for people that are having problems with their coolrunner e.g. no greenlight atall.
E.G...
-Check the correct file has been flashed to the coolrunner
-Check your motherboard version (there was a post with a person that had a cap installed and so thought it was a jasper when it wasnt).
-Check continuality betwean all the points using a multimeter paying special attention to point B (alot of people are having problems there).
-Check the .ECC file was created using either python directly or 360 Multi Builder v0.4
-Check the switches on the coolrunner are selected properly.
-Check the nand has no bad blocks in the first 50 blocks (where the ECC file goes). If it does then remap them using Martin C's guide in the sticky section.
-Check there arn't any bridged points.
Just some ideas, having all of the troubleshooting problem solves in one post would be very helpful.
E.G...
-Check the correct file has been flashed to the coolrunner
-Check your motherboard version (there was a post with a person that had a cap installed and so thought it was a jasper when it wasnt).
-Check continuality betwean all the points using a multimeter paying special attention to point B (alot of people are having problems there).
-Check the .ECC file was created using either python directly or 360 Multi Builder v0.4
-Check the switches on the coolrunner are selected properly.
-Check the nand has no bad blocks in the first 50 blocks (where the ECC file goes). If it does then remap them using Martin C's guide in the sticky section.
-Check there arn't any bridged points.
Just some ideas, having all of the troubleshooting problem solves in one post would be very helpful.