Reset Glitch went bad Jasper :::: HOUSTON I HAVE A PROBLEM

[rroddr]

Apparently I made a big mistake the otherday I beleive i clicked the wrong nand sixe for the jasper mother board nand dump. Also I didn't check if the console had failed an update before I worked on it and was just advices today by the customer that it did fail..

When i tried using the ecc file that created after the dump I get a black screen

When I turn on the console with rgh disabled and original nand back on 3rrod= 0022

When I used a nand off of the other jasper in my posession stock nand 256MB- 3rrod= 0022
Ecc from the other jasper = black screen

What can I do to correct this or if I need a new nand completely please help I don't want to explain to my customer that I messed it up (well atleast on a positive not I do have another console I could swap it with but I would rather give him the same console he gave me)

 

[trippy86]

I would Check PLL_BYPASS point and make you havnt bridged any points. Also may be worth looking at Martin c LDV post. Also would be usefull if you could post some pics of your soldering

 

[paul.86]

Try build a a ecc from your nand dump flash this boot with eject

Check your av/hdmi I get a few that won't work with hdmi but go fine with av and viceversa if this fails redo your wires I know they look good all mine do but I still rewire every now and then

You cannot do your ldv without your key xell booting

Sent from my HTC Vision using Tapatalk

 

[trippy86]

Sorry your right you need xell first, I stand corrected

 

[neophyte5001]

As long as you have at least the first 64 you should be fine. I have a 512 BB Jasper and the first 64 is all I needed when I first glitched. You don't specify what your using to create ecc but if you havn't already you might give 360 multi builder a go. Hope you get it going!

 

[spookyman166]

If you have COMPLETELY screwed it up. Get a Spare NAND, Try every LDV from about 1 to 11 (thats the highest ive seen in ANY console) and just start flashing till you hit something...