- Dec 1, 2011
- 45
- 6
Hi,
i wanted to update my cousins phat liteon 02510 back to stock before i do a dashboardupdate via usb to the latest dash and then install ixtreme 3.0.
Now I followed the guide on here and the jungleflasher guide. I am basically done i just dont know if i made a mistake at the end. I am using the latest jungleflasher.
"Key has been tested and verified, thanks C4eva !
Sending Lite-On-Erase request to port 0x0000
..............
Drive returned Status 0x80
......
Serial flash found with Status 0x72
Manufacturer ID: 0xEF
Device ID: 0x11
Flash Name: Winbond/NEX(W25P20/NX25P20)
Flash Size: 262144 bytes
Getting Status from port 0x0000
SPi flash found with Status 0x72
Sending Chip Erase to Port 0x0000
Erasing:
Writing target buffer to flash
Writing Bank 0: ................
Writing Bank 1: ................
Writing Bank 2: ................
Writing Bank 3: ................
Flash Verification Test !
Reading Bank 0: ................
Reading Bank 1: ................
Reading Bank 2: ................
Reading Bank 3: ................
Write verified OK !
Sending Vendor Outro to port 0x0000
Drive is Lite-On.. "
After that it says nothing but in both other guides it says "key found in keydb at record....key is...."
Under MTK Flash-> drive properties everything is right except "DVD key not found".
But at the start of the procedure i verified keys under firmware tool 32-> source->verify key.
What did I do wrong?
How far do i need to put the xbox back together in order to update dashboard via usb?
i wanted to update my cousins phat liteon 02510 back to stock before i do a dashboardupdate via usb to the latest dash and then install ixtreme 3.0.
Now I followed the guide on here and the jungleflasher guide. I am basically done i just dont know if i made a mistake at the end. I am using the latest jungleflasher.
"Key has been tested and verified, thanks C4eva !
Sending Lite-On-Erase request to port 0x0000
..............
Drive returned Status 0x80
......
Serial flash found with Status 0x72
Manufacturer ID: 0xEF
Device ID: 0x11
Flash Name: Winbond/NEX(W25P20/NX25P20)
Flash Size: 262144 bytes
Getting Status from port 0x0000
SPi flash found with Status 0x72
Sending Chip Erase to Port 0x0000
Erasing:
Writing target buffer to flash
Writing Bank 0: ................
Writing Bank 1: ................
Writing Bank 2: ................
Writing Bank 3: ................
Flash Verification Test !
Reading Bank 0: ................
Reading Bank 1: ................
Reading Bank 2: ................
Reading Bank 3: ................
Write verified OK !
Sending Vendor Outro to port 0x0000
Drive is Lite-On.. "
After that it says nothing but in both other guides it says "key found in keydb at record....key is...."
Under MTK Flash-> drive properties everything is right except "DVD key not found".
But at the start of the procedure i verified keys under firmware tool 32-> source->verify key.
What did I do wrong?
How far do i need to put the xbox back together in order to update dashboard via usb?
Last edited: