JTAG RF board problems after jtag

J

jaycboy

VIP Member
Mar 28, 2011
488
0
UK/Barnsley
Having trouble with this jtag sumone else had a go at. They took off the r2p12 so i solderd a 10 ohm resistor to the traces and the RF panel started working again like it should i dumped and flashed as i have done a million times before. My soldering is underneath the board using the 2 diode falcon method I have not solderd to the RF board although i tried and it still does the same. I flash xell got freedash installed but now the RF panel is un responsive it will not turn on when i push the button.I can start the xbox with a wired pad as long as the RF panel is not plugged in.I have tried different RF panels I have desolderd re solderd i am at a loss the only time i can get it to boot using the RF panel is if i just shove it in while power is to the xbox.The weird thing is the lights work fine and when it does boot with the RF board inserted the xbox can be turned off with the RF board !!! :(
 
J

jaycboy

VIP Member
Mar 28, 2011
488
0
UK/Barnsley
yes it works fine althou am going to try re writing the nand incase the problem was casued then also seems to boot wen i jiggle the RF board...and modded as in different colour lights on the RF ??? i have a few of these....Thanxs !!!
 
J

jaycboy

VIP Member
Mar 28, 2011
488
0
UK/Barnsley
update no its not working when i flash the original nand back now wonder what ive done :s
 
J

jaycboy

VIP Member
Mar 28, 2011
488
0
UK/Barnsley
It was working fine with the 10 it turned on and off i had problems when i started screwing it into the cage it jus would not work i was trying to find what the problem was but i couldnt see anything i own 3 jags and have done many before but never run into one as stubbon as this re solderd really tidy tested all fine did the noob stuff from step one but still ther must be sum sort of short or something.grrrr.lol
 
You must log in or register to reply here.