RGH 2.0 Jasper - Flashed Back to Stock - RROD 0022

[DoctorJ999]

Hello I am Trying to RGH 2.0 My Jasper BB 256, I had it glitching with RGH 1, but it wouldnt boot Xell, i looked at the NAND and saw it was a 6752, so i went an updated it to 14179. Now the CB is 6753, and it doesnt Flash Green anymore. Re- Do My soldering?

EDIT: Flashed Back to stock and i got RROD, error code 0022.

 

[tattoome25]

Did you install the rgh2 wiring along with all the resistors that need to be in place(depending on coolrunner version) and the 0022 error just a long shot but when you wrote nand back was it from your dump of the 6752 if so since you updated you need to change your ldv by one to account for the update because old nand(6752) probably has a lower ldv which cand be changed with jrunner:smile:

 

[webnomix]

Have a look here, this should explain how to fix your 0022.

http://www.team-xecuter.com/forums/showthread.php?p=498012#post498012

 

[DoctorJ999]

I went to the Alternate Post Out, and now its glitching but it doesnt boot into Xell, flashing back to stock now to see if i get RROD

---------- Post added at 20:04 ---------- Previous post was at 19:55 ----------

Flashed back to stock, boots 14179 perfectly,

 

[jonboy419x]

Most boot problems seem to be with the cpu_rst wire with rgh2 I struggled for hours with the config but what finally worked was using the stock blue wire routed over top of fan shroud and a 10ohm res on coolrunner side most of the time it boots in under 30 sec