For some reason i can't update my xbox because it won't recognize the ethernet cable, so the green light blinked on RGH 1, but then i found out it was on and un glitch-able CB for Jasper RGH, so LoneWolf told me i could RGH 2.0 it, but the green light doesn't blink anymore[I did change the Wires to RGH 2.0, I Have a Rev C] When i flash back to stock, it boots no problem, would i have to update it? How would i update it without ethernet?
RGH 2.0? on 13XXX Dashboard?
- Thread starter DoctorJ999
- Start date
Re: RGH 2.0? on 13XXX Dashboard
Well I was working off a post in the Jasper Fix thread that said 6752 was glitchable via RGH2, perhaps that was incorrect. Go to http://support.xbox.com/en-US/xbox-360/system-updates/system-updates-info and download the USB install package. Unzip it to a flash drive, plug the flash drive into your console, update to 14719. Re-dump your nand, rebuild your ECC, try glitching again.
Well I was working off a post in the Jasper Fix thread that said 6752 was glitchable via RGH2, perhaps that was incorrect. Go to http://support.xbox.com/en-US/xbox-360/system-updates/system-updates-info and download the USB install package. Unzip it to a flash drive, plug the flash drive into your console, update to 14719. Re-dump your nand, rebuild your ECC, try glitching again.
Acton1
VIP Member
you don't update dash via ethernet mate
what was your original dash before you did RGH ?
what was your original dash before you did RGH ?
Last edited:
Acton1
VIP Member
ok mate that should be glitch-able with RGH1.
What CB does it have ?
you will need a cb of 6750 or above
What CB does it have ?
you will need a cb of 6750 or above
Last edited:
Ok, so i boought a flashdrive, and added the system update to my USB, I try to install it and it says
"Can't Process the update. If the problem persists, go to www.xbox.com/support.
Status Code:
335A - 397F - 1600 - 0700 - C000 - 000E"
What should i do? I dont have a Harddrive, but its a jasper 256.
"Can't Process the update. If the problem persists, go to www.xbox.com/support.
Status Code:
335A - 397F - 1600 - 0700 - C000 - 000E"
What should i do? I dont have a Harddrive, but its a jasper 256.
vrtclhykr
Senior Member
You are stuck in an update loop. My guess is you have a FW modded drive and will not properly update. If you run the 2nd set of Hex numbers through a Hex to Decimal converter you will see that you are stuck in a 14719 dashboard loop.
1st off you need to get out of the loop. Easiest way is to put your DVD back to stock and then run the USB update. It will allow the update to finish once your drive is stock.
1st off you need to get out of the loop. Easiest way is to put your DVD back to stock and then run the USB update. It will allow the update to finish once your drive is stock.
Acton1
VIP Member
jsinger47
Troll Eating Dogs
I have an unmoved DVD Drive, i didn't have the DVD Drive plugged in at all, so i guess ill try it with it connected