RGH RGH 2 attempt gone wrong, Does anyone know how to help?

[shippppppy]

Hello people, It would be great if someone had a good answer for this.

First of all lets get started with what i used.
-------------
CR3 Lite
Trinity Motherboard
x360 super nand flasher
jrunner
-------------

Ok here is what the problem is.
I read the nand three times and got it all three nands as the same.
I then programmed the coolrunner.
Now this is where i notice there is something wrong. When i was done programming the coolrunner 3 lite i went to create the .ecc image. Now i got this error.
Header is wrong..
Invalid Image
Failed to create ecc image
Now I had a old dump from this trinity from about a week ago when i was going to RGH it. But something else came up so i only got the nand.
That nand worked just fine in Jrunner.
So then i tryed again to create the .ecc image. It worked fine.
Then i wrote it with no errors.
Then i went to go get the cpu by launching the console. When i looked at the cr3 lite the red lite was very week like almost a light orange color. I did not worry about it to much. I put on the ROL board and turned on the console. The fan ran for about a second and the whole console just when 100% off. I attempted to turn it on again. Absolutely NOTHING happened. It was almost like it was not even plugged it. "And yes i did check to see if it was plugged in."

I am not sure really what to do now. I am just sorta looking at it...
If you know whats wrong with it or if the console is just dead please tell me so i know if i should waste my time working on it more.

Thanks,

 

[Sasuke Uchiha]

Where is your pictures of your soldering

 

[stucknvegas]

Fill out the Template .. Please Also that CR-3 lite chip has not ben available in years ..So if you purchased that on Ebay we do not support cloned chips
So we need a clear picture of your CR-3 lite

 

[BrockThunderjam]

You should probably find someone local to you to help you. Post in the services wanted section. I'm guessing as has been pointed out above that your cr3 lite is a fake so you wont get proper support on the forum.

 

[shippppppy]

OK it seems like you guys seem to be concerned about a "Clone" Here is some pictures of the CR3 Lite. I really don't know if it is a real working one or not

Sorry i could not get to close to the CR3 Lite because it would be 100% blur.

 

[BrockThunderjam]

That's a clone. You could have just said where you bought it from and that would have confirmed. There are only a handful of official resellers around. And unfortunately most of them dont have much stock and are closing down shop, so getting authentic TX stuff is harder and harder. That said, you should post in the services wanted section and see if someone can help you out. You wont get help with your clone.

 

[shippppppy]

That's a clone. You could have just said where you bought it from and that would have confirmed. There are only a handful of official resellers around. And unfortunately most of them dont have much stock and are closing down shop, so getting authentic TX stuff is harder and harder. That said, you should post in the services wanted section and see if someone can help you out. You wont get help with your clone.

Alright, Sounds good. Thank you