RGH RGH 2 Jasper not glitching

[LordTheron]

Hi,

I have problem with my jasper 16mb. I can get it to glitch but only sometimes.

I can get it to glitch only on 50cm single shielded cable with no ground cable. Even then it booots 2 in 10 attempts. As soon as i solder ground cable it wont glitch at all.

If I use shorter cable it wont glitch at all, if I use shielded cable that comes with cr rev c it wont boot at all, If I use standard cable for d point it wont boot at all, if i short cap pard for jasper on cr rev b it wont glitch..

I have tried also routing the cable in many different ways with no luck.

Also tried all timing files and with file D I get some glitch, none of other ones would glitch it (not even once).

Anyone got any idea how to go about it? help much appriciated.

 

[BL4K3Y]

This is exactly why we ask for images!

We cannot assist you until we can see your work.

 

[LordTheron]

cr is removed from the console, I will wire it back in, and post photos shortly.

 

[WNYConsoles]

Did you remove the two resistors from the CR at C15 and JP and bridge them with solder? I see this a lot on the forums and it annoys me as it is clearly states to do this in the official tutorial.