Hi all I was hoping someone may be able to direct me to an answer to my issue. I have RGH a Version 2 Corona without any issues or problems. The console boots and runs software. I did how ever manage to burn out the drive that was in the console which was a Hitachi DL10N with 0502 Firmware. I purchased a Liteon DG14d4s drive with 9405 Firmware and a TX PCB Board and have installed it into the new drive. Now the drive will only Open and Close and the drive will only say PLAY DVD on the Dashboard. It Does Not recognize the game disk. I have done the following things already, I Have create a couple of different NAND Images with the FCRT.bin file enabled and Disabled. (Did not work) (Console booted Fine with all these Images ) I create a couple of NAND Images with the DVD Key Pasted in the Advanced Settings of J Runner. (Did not work) (Console booted Fine with all these Images Flashed) I have flashed the New PCB Drive with Stock and Iextreme Firmware with the DVD Key Spoofed to the Firmware. (Drive is picking up but will not read a game disk comes up with Play DVD only. Then boots into the white xbox360 screen) I tried flashing the drive with the Hitachi 0502 Firmware instead of the Liteon 9405 Firmware. ( Jungle flasher wont allow me to do the Flash) So I am wondering can I even get this drive working on this console with the TX PCB Installed? Will TX Fusion 1.09 Beta Version Work on a Coronas V2 Console to flash the Drive? Or am I better of cutting my loses and buy the new PCB for the Hitachi Drives and Flash those instead? Any help and suggestions are appreciated Thanks all
RGH and Console Drive Swap.
- Thread starter Ozbull
- Start date
BL4K3Y
VIP Member
gazcoigne
BANNED
you cant flash a hitachi PCB
purchase an LTU 2 pcb for liteon or hitachi (if you still have the chassis and laser for the hitachi)
you have your nand image and CPu key to create an LTU 2 image and that will work perfectly - follow the guide on the forum
purchase an LTU 2 pcb for liteon or hitachi (if you still have the chassis and laser for the hitachi)
you have your nand image and CPu key to create an LTU 2 image and that will work perfectly - follow the guide on the forum
BL4K3Y
VIP Member
LTU/LTU2 isn't required for RGH.
He can use WriteKey to prepare his new drive which should work fine as long as NOFCRT is enabled.