RGH Bricked Please Help

C

Custom

Noob Account
Dec 19, 2016
1
0
TX Product(s) used: Unknown
Console Type:Falcon
NAND size: 16mb
Dashboard version: Unknown
CB version: Unknown


Description of Problem: So back in April 2016 i bought an RGH Xbox 360 from Ebay. I hade no experience with modded consolse so when i got it the first thing i did was updating the dash like a retail xbox 360... it got bricked so i got help and learnt to use Xell i used that to make an file so a could flash my xbox 360... Didn´t work so now i cant even boot into Xell i have bought an ****** Nand Flasherand tried flashing it with that but i only get errors! And to send it to somebody here were i live (sweden) its $80 to get it repaired but if they cant repair it it will cost $40 for the work that put in... So i realy need help solving this problem. The Person helped me before was "Noobert" over on Se7ensins.com but he didnt know what to do so i hope that someone over here knows what i should do!

I got an RGH 2.0 chip for an Phat Xbox 360 with Falcon Moderboard
 
G

gavin_darkglide

VIP Member
Dec 14, 2012
2,303
118
Since I havnt seen any images, and all you said you have is a non TX nand reader/writer, i will help you. First question, do you have a valid nand dump? Or one with the KV intact? If so, Xell will give you your DVD_KEY. If that is the case, all you have to do is dump the nand as is, and then create a new xebuild image, and flash it back. If xell still boots, you can copy the updflash.bin to the root of a fat32 partitioned flash drive, and boot xell. once it is done flashing pull the power for 30 seconds, and plug it back in. If xell doesnt boot, you will have to flash with the hardware Reader/Writer. Dont touch the glitch chip in any of this. If you cant read/write the nand, try taking a screwdriver and shorting the resistors next to the nand chip, while plugging in the power, once the power has been plugged in, remove the screwdriver, and try reading/writing the nand again. in the image is the SMC, and if it was corrupted, SPI flashing wont work, by doing this, the southbridge loads a failsafe SMC from itself, and will allow you to flash the nand. If these ideas dont work, I have a few others.
 
C

Coltin

Noob Account
Dec 23, 2016
8
0
Hey man let me ask you a question. I'm ready to read my nand but the dash version in the drop menu is not the 17511 dash version like i have on the console. My Jr programmer v2 recognized the console as a Jasper 512mb but I don't want to go ahead with out the dash versions match up. Does it matter? Any idea how I can fix this problem?
 
playingmax

playingmax

Staff member
Troll Eating Dogs
Jul 7, 2005
4,875
128
New York/Westchester/Putnam County
team-xecuter.com
Last edited:
You must log in or register to reply here.