RGH falcon with dash 15574

speed3r

Junior Member
Nov 30, 2011
19
0
Behind you
Hey,

So first a little background story:
Yesterday i got a falcon with a 0001 rrod after opening it i found out that the mosfet chips where oke and it had 5 popped caps (16v 1500uf 105°) so i got some of my spare xenon board and replaced them and bam instant boot.
Then i found out it has dashboard 15574 on it and i have been out off the modding for over 2 years now but i readed that any dash can be rgh now?
If so i can order Coolrunner Rev C for like 10 bucks and i already got a matri(x) nand programmer but the cr rev c is empty and i cant order jr runner to program it nor can i get a CR4 in my country.
i already got a ltp cable from the old days to program a x360glitch chip can i use it the same way on a cr and put a 3v3 and ground on the left pads of the cr to the dvd drive power or nand points and put the lpt cable on the jtag points?
also do i need something else?

Do i need the use rgh 2.0?

Here is a pic from my lpt cable dont mind the x360glitch sh*t chip
10eg9jo.jpg
j125ja.jpg
 
Last edited:

Utmad

VIP Member
Aug 15, 2010
3,304
118
Southampton, UK
Yes it will be RGH2 but i seriously doubt youll find a genuine rev c tx coolrunner it will most likely be a fake.

remember this is a TX product support forum so you will not get any help with the stuff you mention.
 
Last edited:

speed3r

Junior Member
Nov 30, 2011
19
0
Behind you
Yes it will be RGH2 but i seriously doubt youll find a genuine rev c tx coolrunner it will most likely be a fake.

remember this is a TX product support forum so you will not get any help with the stuff you mention.
Yep you right i will remove the other stuff from my post ;)
But it says its the real deal for the coolrunner rev c and not a fake/clone.
Also can i flash the coolrunner chip with my lpt cable and 3v3 & gnd from the xbox (dvd cable)it self?
And i guess that the xbox needs to be on when programming the cr chip with my board timing files?
 
Last edited:

Krafter

VIP Member
Apr 17, 2011
3,737
118
Indiana
I'll sell you a real Rev C. It is not fake. See how easy that is to say? (You will however receive a fake and not know it until you post here asking for help.)

As said above, I doubt you'll find an authentic Rev C. Just because someone says it's real doesn't mean it is. Add a few more bucks to the 10 and get a CR4. RGH2 Falcons suck anyway and are a bitch to make stable unless you know what you are doing.

I should also add that LPT isn't supported here either.
 
Last edited:

hersheys247

VIP Member
Dec 25, 2011
1,128
88
Detroit area, MI, USA
And i guess that the xbox needs to be on when programming the cr chip with my board timing files?
No
................

I have 2 genuine rev C I just found last week, but your mention of the word "country" suggest your not in the States!

Sent from my brain tumor causing device using tapatalk