Rgh Freezes at Logo Screen

[dil_king]

Ok So I got the cpu key I even had xell start and then I installed the hacked 14719 dashboard but when I turn it on it freezes at the logo screen and does nothing I can eject the dvd drive but the screen is just frozen at that screen what is wrong anybody know ? does the same thing when I return the xbox to retail nand. Something to do with the LDV? this is a slim.

 

[BL4K3Y]

Is it a phat or a slim console?

If it is a phat, how have you routed the wires underneath?

 

[dil_king]

Is it a phat or a slim console?

If it is a phat, how have you routed the wires underneath?

SLIM

 

[playingmax]

how have you routed the wires underneath?
n check ur ldv it should be set to 1

 

[dil_king]

how have you routed the wires underneath?
n check ur ldv it should be set to 1

yep it is at 1

 

[BL4K3Y]

Did you write the image using RawFlash?

If so, try writing it back with NandPro.

 

[dil_king]

yep I wrote it with nand pro

 

[BL4K3Y]

What about bad blocks?

Did your original dump report any at all?

 

[dil_king]

What about bad blocks?

Did your original dump report any at all?

no bad blocks nothing

 

[playingmax]

can u post some pics of ur work.

 

[oO Elite Oo]

Show pictures of your wiring so we can see your work

 

[dil_king]

here are the pics

 

[AteOeight]

Coil CPU_RST, and tuck under leg of xclamp, or coil it like this... works for me. I just noticed your black wire, never that that in any of my installs.

 

[BL4K3Y]

Can you take a close up photo of the wiring on J2C3 please.

 

[dil_king]

Can you take a close up photo of the wiring on J2C3 please.

If I flash the retail nand back to it still freezes and here is the pic you requested

 

[BL4K3Y]

Try flicking your CoolRunner console switch to PHAT if you haven't done so already as many have reported that this works for them.

 

[playingmax]

Coil CPU_RST around the x-clamp always works for me. Also ur alternate STBY_CLK wire is way too long. cut it down. als a close up of the alternate point ur using not looking good to me. if anything try using FT3N2

 

[dil_king]

flicking the switch to phat does not work and I made an interesting discovery that when I turn on the xbox and remove the ROL board the xbox boots further into the dashboard but freezes.

I was able to boot into the dashboard but i keep getting message "fatal crash intercepted" and it boot with out the ROL bord int the xbox

 

[DayvG]

Try a POST QSB. I have one on my slim and its spot on. A lot of slim boot problems are down to the CPU_RST wire and the POST QSB is a great solution.

 

[AteOeight]

I think I got it, your dash launch.ini settings! Sounds like thats where the problem lies.