ok lets preface this, this is my first rgh. did it the other day all seemed fine. today turn it on and during boot up it froze, i turned it off, powered it back on get E79, power it back off the back again and no boot at all, no green lights no red lights. only light on is the coolrunner red light. any advice?
RGH rgh freezing?
- Thread starter paccoinca
- Start date
Check wiring and soldering. Check any points for damage if it's showing. I signs of life check the stby_clk point
Last edited:
Fisticuffs
VIP Member
surely your phone has a camera that would be better than those pictures or a webcam.
Fisticuffs
VIP Member
@ paccoinca you can resize the pictures with windows paint, Open the pic in paint, Click on resize, Tick maintain aspect ratio, Either use percentage or pixels, Resize and reupload
Edit : NVM you can't with these
Edit : NVM you can't with these
Last edited:
juanbrnt
VIP Member
just review what you did check wiring n soldering point ,use a multimeter to check continuation , check the light in the power brick ,if all this is good try to flash the org nand back and see what happen
Fisticuffs
VIP Member
Fisticuffs
VIP Member
I don't have an HTC evo, But I'm sure you can adjust the settings... To make it high res. I have a much crappier phone, And I can take better pics than that.
Here's my lunch....
Edit: Maybe crappy isn't the right word, It's not on the higher end as an EVO
Here's my lunch....
Edit: Maybe crappy isn't the right word, It's not on the higher end as an EVO
Last edited:
+1 on this
Have it repaired properly.
could be worth flashing it to stock just to rule out the RGH.
But I'd put my money on the solder under the gpu going out
im trying to flash it back to original but when i click to program coolrunner jrunner stops working and it shuts down. running jrunner 263 im starting to get lil mad as i have a bad temper this morning
Fisticuffs
VIP Member
What type of board is it?, Better pictures and more info will help.
Also J-Runner is now up to 267, But I doubt thats the problem.
Also J-Runner is now up to 267, But I doubt thats the problem.
Last edited:
If j runner dosent work just use nand pro :rolleyes2:
Just flash back the stock nand and swtch the coolrunner to programme to turn it off
Just flash back the stock nand and swtch the coolrunner to programme to turn it off
Last edited:
i know trying to find dl for 267 but cant. im gonna try to get better pics, and its a falcon board
nand pro has nothing to do with Jrunner
Its a programme on its own,
Been used for years on 360's and is extreamly stable
I can pretty much guarantee that its on its way out with rrod.
X clamp kits are no real repair and do more damage than good
Its a programme on its own,
Been used for years on 360's and is extreamly stable
I can pretty much guarantee that its on its way out with rrod.
X clamp kits are no real repair and do more damage than good
Last edited: