RGH help

[bigchangibson]

ok i was making a falcon rgh with the cool runner rev c and i read the nand and everything installed the chip wrote the ECC to it and tried to start it to get my cpu but it wont boot up it just keeps flashing ive had it on for about 20 mins and then i turned it off what should i do please help thank you sorry guys i checked everything and so far it looks right and it wont boot so i can get my cpu key what should i do:frown::frown:

 

[talby71]

http://team-xecuter.com/forums/showthread.php?t=96474

 

[gazcoigne]

falcons can be very picky for RGH2 takes a lot of tweaking to get boots and avoid crashes and freezing.

try and source a R-JTAG they kick ass

 

[Taijigamer2]

falcons can be very picky for RGH2 takes a lot of tweaking to get boots and avoid crashes and freezing.

try and source a R-JTAG they kick ass

True story.

 

[jekdyell]

if your falcon is on a rgh2 dash.then remove the c8 cap from the rev c,set switch to slim,try timing file B.and 30 to 40cm kynar wire for the cpu_rst wire topside of the mobo.

it's all about the route of your cpu_rst wire.

 

[bigchangibson]

i just perchased the r-jtag and it looks simple enough i already started it thanks and it seems to be working thank you so much im about to rgh my trinity and im sure i going to get something wrong lol but i got my jasper on my first try so i might get lucky lol thx

 

[gazcoigne]

use your coolrunner on the trinity they are easy peasy with RGH 2

good luck!!