RGH RGH HELP

H

HeLL HAZARD13

Senior Member
Jan 15, 2012
106
0
ok so i finally solder everything right and i read my nand:smile: but i did every thing and i was trying to turn on my coolrunner but it does not turn on and my power brick gets red every time i turn it on do and i need it to run to xell could i just get another cool runner or am i f**ked?
 
N

neophyte5001

Senior Member
Nov 5, 2011
113
0
Missouri
Hmm, I would've gone with QSB's, the coolrunner one has a resistor that cleans up the signal from the HANA. Or, at the very least, some pin headers. That said, how about some pics of the rest of your soldering? I can't spot what's wrong but anyone else will prolly want to see pics.
 
H

HeLL HAZARD13

Senior Member
Jan 15, 2012
106
0
dgenx said:
it's a solder issue.
i say send it to a pro near you.

why start a new thread when you have one on this already.

http://www.team-xecuter.com/forums
/showthread.php?t=80494
Click to expand...
cause i do not know how to add a pic after i posted it

---------- Post added at 16:15 ---------- Previous post was at 16:13 ----------

and i tryed to connect my nand x to it with every thing desolderd but it makes my nand x turn off and the cool runner stays off
 
H

HeLL HAZARD13

Senior Member
Jan 15, 2012
106
0
xbox360 hacker said:
Do as martin says. If the power brick light is going red every time it is an indication of a short at the very least.
Click to expand...
but if i get anouther cool runner cause this one does not work i de-solderd every thing from th cool runner and i connected it to my nand x and all it does is turn off my nand x and the cool runner does not turn on
 
You must log in or register to reply here.