RGH Lifted pad on nand R4B254

[denka]

Need some advice.

Ive have a lifted pad on the nand R4B24. I was wondering if the was a fix out there.

Ive noted that the resistor next to this outs into the pad, does that mean I could add a jumper wire from its side to the track after the lifted pad? Its all on the same track so In theory I think it could be possible but Im not 100%.

Any advice or thoughts out there?

Im hoping so, I cant be the only person to have cock'd this up?, can I?

To add I had the RGH 13604 working fine but the nand wire popped off, not using any QSB's although I do have them, I just wasted one trying to fix the issue with no luck.

Jasper 256MB

 

[barryhughes]

possible to get an image of the damage?

 

[denka]

I've been quite busy so I haven't replied to this thread but wanted to update it.

I manged to salvage the RGH by creating the jumper wire as previously thought, will post up some pictures when I get home from work so that others can benefit from my little discovery.

I haven't seen anyone else with this solution as I searched high and low before I came up with it so I will say I must be the first.

Its also worth mentioning that you dont actually need to solder the wire to that pad if your having trouble with it. You can just solder the wire to the left contact side of the resistor that sits to the right of the pad.

Hope this helps others with the same problem.