Rgh not working after dash launch 2.28 installed

[actiondanuk]

I rgh a friends trinity last week, all has been working fine untill today, when he decide to try and put dashlaunch 2.28 and freestyle dash on it.

Dashboard version is 13604.

Not sure what happend when he installed the patches, but it doesnt glitch now.

All he say's he's getting is the coolrunner light goes orange then red and no green light at all??? And doesnt boot to the dashboard.
But xell still loads if you use the eject button.


Any help would be great on this,

cheers,

Dan.

 

[x360ccm]

write the orig image back to it.the one you did when you first rgh it.

 

[actiondanuk]

write the orig image back to it.the one you did when you first rgh it.

Original nand.bin or freeboot.bin?

 

[x360ccm]

the freeboot image you first put on it when it worked fine..see if it glitches then.

 

[actiondanuk]

the freeboot image you first put on it when it worked fine..see if it glitches then.

Ok ill give that a go. He's gonna come over with it later.

If there was a problem with the wiring would xell boot with the eject button or not??

And thanks for the speedy replies

 

[broettge]

If Xell is loading, the glitch is working!

The problem is either
a)something in the nand was corrupted when trying to install dashlaunch and FSD
or
b) a bad dashlaunch config

As previously stated, I would recommend reflashing the freeboot.bin image.

 

[Martin C]

He's done more than he said.

 

[actiondanuk]

He's done more than he said.

I think so as well, cant be sure till I get the console back here.

Hoping that re-write of the freeboot.bin will sort it.

Would it also be wise to delet any crap off the 250gb hdd that may have been put on there???

 

[actiondanuk]

Just a quick update on this one, mate had pulled off the orange wire when he had opend the case, so I re-attached it, but it still didnt boot. So I re-wrote the freeboot.bin and now all is well and boots pretty quickly.
Thanks to all for the help above!!!

Thread can now be closed.

 

[Martin C]

Thanks for letting us know!