RGH RGH Question

[Road-Runner]

Ohk i have an important question about my rgh. Well if i have an rgh can i take the nand and make it to the lowest dash to were is jtagable not RGH but jtagable becasue im wanting to jtag it instead of the RGH because zypher rgh is really bad and desnt boot all the time so just want to unsolder all the points after i lower the dash and just jtag it. This though came to my head because after i update my rgh to the newest dash i took my old nand and lowed it and it took me like 5 dashboard back witch wansnt a jtagable dash but it took me back so then i updated it back the the newest dash...

 

[Road-Runner]

No. The JTAG/smc hack isn't depending on the dashboard version. It depends on the CB version allowing the vulnerable kernel to load. Once your CB is updated to prevent the JTAG/SMC hack, there is no going back.


Sent from my iPhone 4S using Tapatalk

Ohk Thanks !!!

 

[ponuod]

RGH is the future, forget about other tricks, and use DEAMON for the TX sake.

 

[Vest1ge]

A Zypher can give a very good boot time, I had one that was an instant boot everytime!

But its more than likely a wiring issue, or interferance. Run the blue wire along the top infront of the fans. And the Green one under the X-Clamps. This will improve boot times.

 

[Tag234]

Zephyrs, Jaspers and Falcons can all achieve nearly instant boot times using correct wiring paths and sometimes a few capacitors. In fact, nearly every phat I have done boots faster than the slims.

 

[Wretched]

Same here the boot times on all my fat RGH are like jtags. The slims I just power on by power button then by the time I sit down and change the tv input it is ready to go.