Hello guys,
I have rgh master phat. Modded by someone a month back. Since few days I was noticing the light of the chip that comes out from the hdd mesh wasn't at the same position as it was. So I opened it and the chip was literally 80% hanging. That tape which was holding it over the top a/v ports has came off (bad install). I put my phat vertically edue to lack of space on my table. So I'm little concern about it. I have removed the old, dirty double sided tape which was there. I have surgical tapes at home (fabric and paper). Should I use the fabric(very strong grip) tape or paper tape on top of a/v port and then place the chip on top of it with a tiny drop of super glue? what do you guys recommend me to do. Any exper t there?:biggrin:
Thanks.
I have rgh master phat. Modded by someone a month back. Since few days I was noticing the light of the chip that comes out from the hdd mesh wasn't at the same position as it was. So I opened it and the chip was literally 80% hanging. That tape which was holding it over the top a/v ports has came off (bad install). I put my phat vertically edue to lack of space on my table. So I'm little concern about it. I have removed the old, dirty double sided tape which was there. I have surgical tapes at home (fabric and paper). Should I use the fabric(very strong grip) tape or paper tape on top of a/v port and then place the chip on top of it with a tiny drop of super glue? what do you guys recommend me to do. Any exper t there?:biggrin:
Thanks.
Last edited:
