RGH to remove a flag

[danbudzenski]

I got the unsupported disc message and almost 100% sure im flagged. I ordered a nand x and coolrunner to build a clean nand and hopefully dump the flag so i can use my system to play on live again. The question i have though is after writing the new clean nand can i leave everything soldered to the board and the coolrunner in place or do i need to remove all of the hardware before playing online again on unmodified firmware. Is there a way to just disable to the RGH so that later on i can use it without having to reinstall?

Thanks

 

[ishockin]

if you already connected to live then you ccant remove the flag, and yes you can disconnect the 3.3 from the coolrunner so you can use your xbox on live again but you have to flash back the original nand first

 

[keil423]

if you already connected to live then you ccant remove the flag, and yes you can disconnect the 3.3 from the coolrunner so you can use your xbox on live again but you have to flash back the original nand first

Your clean nand!

 

[danbudzenski]

thanks for the quick response. I got the flag offline and havent been online since. I think i should be ok server side.

---------- Post added at 21:48 ---------- Previous post was at 21:45 ----------

so if im thinking about this correctly:
-install nand x and coolrunner
-dump nand to get cpu key
-build new clean nand for my mobo version
-write new clean nand to the xbox
-desolder 3.3 V wire from coolrunner and qsb
-play on live again

 

[Martin C]

Yep, that's the monkey.