RGH: XeLL not loading

[kasp9]

hi!

I followed this tut http://team-xecuter.com/forums/showthread.php?t=75945 to the letter on Jasper 16mb (nand chip hynix HY27US08281A), got 2 good nand reads (no bad blocks), created and wrote .ecc to the box.
Problem is: XeLL reloaded doesn't load. Green led on rf boards blinks constantly, Coolrunner has red power led on, green one blinks every ~5secs and blank screen (weather tv or pc monitor, hdmi or component all the same..). Waited for 5min and nothing..
Blue wire avoids problematic area on board.

Please, give me some suggestions what should I check , recheck or do next to get XeLL loading on my box

Thanks in advance, your help is appreciated!

Kaspars

 

[diaboliq20]

so you flashed the coolrunner correctly - how did you build the ecc?

 

[seanr28]

Have you tired re-positionon of the green wire also? as this can be an issue as well

 

[kasp9]

I've flashed coolrunner with jasper.xvsf in nandpro 3.0a when I got it and also in Jtag tool (just to try it) as writen in aformentioned tutorial I followed.
.ecc was built in Jtag tool

---------- Post added at 16:35 ---------- Previous post was at 16:32 ----------

I'll try that at home, but I'm pretty sure green wire didn't even come close the problematic area because of its length

Have you tired re-positionon of the green wire also? as this can be an issue as well

 

[diaboliq20]

use mutlibuilder to build the ecc

 

[ccNick]

The green and blue wire can both easily touch the bottom of the coils, I have started routing the green cable under the xclamps and have had no problems at all since doing this.

 

[keith6625]

try multibuild 4 and rawflash or best pig ecc gen i have not had any luck with the jtag tool with jaspers


edit: and i have also had luck with taking the green wire through the smaller hole next to the bigger one well only done it on one but it booted first try will try to get a pic of it up just be careful the wire and the hole are just about the same size you have to feed the through carefully or you will split the wire

and sorry for the crude pic but it was the best i could come up with without taking the console apart